DEEP SUCTION ELECTRIC pump JAP
The self-priming centrifugal deep suction electric pumps series JAP have been designed to pump clean water from wells of at least 4” when the water level is more than 8 m deep
- Liquid temperature not higher than 35 °C for domestic use (CEI EN 60335-2-41) or 60 °C for other use, while the ambient temperature must not be higher than 40 °C
- Flow rate up to ~ 3,6 m3/h
- Heads up to ~ 50 m
TECHNICAL FEATURES pump JAP
- Pump body: cast iron G20 with anti-corrosive coating
- Motor bracket: in die casting aluminium UNI 5076 (cast iron for JAP 150-200)
- Ejector: cast iron G20 with anti-corrosive coating
- Diffusers, Nozzle & Venturi tube: Techno-polymer
- Impellers: polymer (stamped brass UNI-EN 12165 on demand)
- Pump shaft: stainless steel Aisi 304 (Aisi 420 F for JAP 80-100)
- Mechanical seal: carbon-ceramics
MOTOR pump JAP
The control motors are asynchronous, squirrel cage-type, closed, with external ventilation
- Incorporated motor protection and capacitor always on, for single-phase models
- The motor protection for three-phase models must be installed by the customer.
- Equipment compliant with current standards should be used
- Class of insulation:F-service:S1-Degree of protection: IP 44
- Terminal board protection: IP 54
Before installation check that the pipes (iron, plastic or rubber) are internally clean so as not to clog the nozzle of the ejector.
A foot or check valve.When assembly is complete, fill completely pipes and pump body with clean water. Formaintaining efficient priming isthere must be a certain one in the circuit pressure, so it is advisable to mount a membrane tank on the delivery of the
pump.
Before installing the pump verify that all the tubes (iron, plastic or rubber) are clean inside to avoid any obstruction of the ejector nozzle. TO foot valve or a check valve must be installed at the foot of the ejector. After the pump is installed, fill tubes and pump body completely with clean water. To preserve an efficient priming a specific pressure in the circuit is necessary, therefore it is recommended to install a membrane tank at the delivery of the pump